一： Routine maintenance for coating machine：

1.Chain parts need put lubricating oil each 1--2 months

2.Screws,especially electrical parts,need check per week at least,make it tight

3.Before each time start machine,check water level ,need more than 3cm

4.After finish one day working,if no use in night,and room temperature below 0 degree,let water out of tank.

5.Change oil for main motor gearbox at least per6 months .

6.At least per three months check oil in air filter,keep it always have engine oil.If oil consumption is not obvious,make value little big,this shall lubricate your machine.

二：Output of the basic slitting machine :

normally one hour finish 1PC jumbo roll( which length 4000m)

Routine maintenance：

1.Chain parts need put lubricating oil each 1--2 months

2.Screws,especially electrical parts,need check per week at least,make it tight

3.Change oil for main motor gearbox at least per6 months .

4.At least per three months check oil in air filter,keep it always have engine oil.If oil consumption is not obvious,make value little big,this shall lubricate your machine.

5.Paper core cutting machine blade shall change all once time,not change piece by piece.for each blade abrasion different. If some new,some old,when operation some core have cut already,some still not finish

三，Adhesive tapes cutting machine feature :

四：1)Automatic control of   PLC system with LCD touch screen control panel , 20 modes for size setting each time & auto changing when cutting.   

2)Auto liquid silicon water spray cooling system                           

3)AC motors for cutting blade and cutting shaft with inverters speed changing .                                              4)Positioning system for cutting: servo motor to control more accurate position.                                          5)Sliding system,high precision liner sliding track and ball screw                                                                    6)Auto cutting angel adjustment ±8° can well protect the cutting blade as well as guarantee the cutting edge flatness.   

7)Single shaft ,single blade